Installation cont..
3
Stage 1
Stage 2
Supplied with the appliance is a plastic (self adhesive) anti-
condensation strip, this should be fixed to the underside of
your worktop along the front edge. The adjustable feet of the
appliance allow it to be raised up to 870mm, if the space
between the floor and the underside of the work surface is
greater than 870mm, then the appliance should be
positioned on suitable wooden spacers which should always
be fixed to the floor. Always use a spirit level to make sure
that the appliance is level left to right and front to back.
(If the appliance is installed on a carpet, ensure there is
clearance beneath the appliance). The four adjustable feet
should be adjusted to the correct height; the rear feet are
adjustable via studs at the front of the appliance (fig 1). To
prevend damage to the floor covering, the appliance must be
installed using the plastic skids provided.
Stage 3
+
-
Measure the width of the decor door.Align the template on the rear of the door with
the top of the door level with the top of the template, and the left hand edge of the
door in line with the measured door width. Mark the four fixing poisitions. Repeat on
the right hand side. Remove the template, and drill pilot holes in the door in all eight
positions using a suitable drill (take care not to drill through the door). Attach the
upper plastic studs and lower fixing brackets to the decor door as shown below.
1 4
Cleaning and Maintenance
fig 1
Connect the water, drain and electrical supplies (230 - 240V, 50Hz, 13A). We
recommend that the appliance is connected to a cold water supply..
Top of Door
Plastic Studs
Metal Brackets
Before carrying out any work, always disconnect the appliance from the
electrical power supply.
General warnings and recommendations
•
Avoid the use of acidic or abrasive detergents.
•
Clean the outer surfaces and door lining of the dishwasher regularly, using a soft
cloth moistened with warm soapy wate.
•
Clean the door gaskets with a damp sponge.
•
Periodically (once or twice a year) it is advisable to clean the cavity using a soft
cloth and water to remove any deposits.
Filter Assembly
For best performance and results, the filter
assembly must be cleaned frequently. The filter
efficiently removes food residue from the wash
water, allowing it to be recirculated during the
cycle. For this reason, it is a good idea to
remove the larger food particles trapped in the
filter cup 'C' and the triangular filter 'A' after each
wash. To remove the filter assembly, pull the cup
handle in the upward direction. The entire filter
assembly (made up of the triangular filter 'A',
cup 'C' and and the fine filter 'B') should be
cleaned at least once a week. To remove the fine
filter 'B' rotate it anticlockwise and lift it away.
Clean the filter and the fine filter, using a soft,
non metalic, cleaning brush. Then, reassemble
the filter parts as shown in the figures and
reinsert the entire assembly in the dishwasher,
positioning in its seat and pressing downward.
The dishwasher must never be used without the
filters. Improper replacement of the filters may
reduce level of the appliance and damage dishes
and utensils.
Cleaning the Water Inlet Filter
Periodically clean the water inlet filter (see figure)
located on the outlet of the water supply tap. After
turning off the water tap, unscrew the end of the water
supply hose, remove the filter 'A' and clean carefully
under running water. Then, return the filter to its place
and tighten the water supply hose back into position.
