Dion-Ag F64-90R, Operator'S Manual, Page: 32 / 38

ADJUSTMENTS
32
Figure 51 Friction disks replacement
1
2 3
2
4
5
6
7
FRICTION DISKS REPLACEMENT
FIGURE 51
The friction clutch protects the machine against over-
loads and reduces the load at start-up. It includes two
friction disks which are under a calibrated pressure.
They are not adjustable and require no maintenance.
In the case of frequent jams and overheated disks, or
if they need to be replaced for any other reasons, the
clutch will first need to be taken apart.
To replace a disk:
1. Tighten nuts (item 7) to remove pressure on the disk
plates (items 5 & 6)
2. Using a hammer and a punch, unfold the tabs (on
item 1). These tabs are holding the spring plates in
place (item 2).
3. Remove the spring plates, the hub (item 3) and the
two friction disks (item 2).
4. Clean the friction surfaces on the hub and the
housing (items 1 and 3).
5. Assemble back in the same order and push in the
tabs to hold the spring plates in place.
6. Loosen the nuts.
Manual No.F6418E996E