PAGE 2
(314) 205-3033
WWW.DIODEDYNAMICS.COM
PP0143
DD6596
Ranger 2019 SS18 Bracket Kit
DD6597
Ranger 2019 SS18 LED Kit White Combo
This installation guide is for the following SKUs:
5. Route your wiring harness. We recommend routing
the harness across the front of the engine bay and
down the front passenger side corner to the lower
grille area. This will require the core-support trim panel
to be removed. It is held in place with four plastic
push-rivets and two screws on the intake.
6. Remove the two 21mm frame nuts shown in the
picture to the left on each side of the vehicle.
NOTE:
Ensure the brackets are
oriented as shown to the left.
8. Connect your new 18” light bar to the wiring harness. Using the included hardware, install
the light bar onto the brackets. Using the adjustment slots, adjust the lightbar so that it is
centered in the lower grille opening. Once adjusted, tighten the 21mm nuts.
NOTE:
We recommend routing the harness before installing the light bar, as it will be difficult
to access the harness once the light bar is installed.
9. Reinstall the lower grille and license plate holder
(if applicable) using the original hardware. Ensure
the mounting clips shown in the image to the left are
properly bent such that they will not push through the
sheet metal backing, that the mounting clip ribs are
pointing rearward such that the plastic panel can be
inserted with minimal interference.
10. Aim your light bar and adjust the final height to complete the installation.
DD6598
Ranger 2019 SS18 LED Kit Amber Combo
7. Using the original 21mm nuts, install your new light
bar brackets to the studs, hand-tightening them only.
Scan the QR code to link to our installation video online!
NEED MORE HELP?
We’ve taken the time to test our products on your vehicle. We can
guarantee compatibility and fitment the first time – no guessing
game! If you need more help with installation, watch our step-by-step
video to walk you through the process.
