3xAA 1,5V
3xAA 1,5V
3xAA 1,5V
6. Reset
6.1 Resetting the chime
6.2 Resetting the doorbell
8. Troubleshooting
7. Explanation of the LED intensity on the doorbell
Press and hold the button for approximately 5 seconds, a tone will sound
to indicate that the code deletion is successful.
Using a screwdriver, open the back panel of the
doorbell and hold down the push button (front) for
15 seconds.
1. You press the push button, but its indicator light does not respond...
What should I do?
a) Check if the batteries have been installed.
b) Check if the batteries are completely worn out. If so, replace them as
soon as possible.
NOTE: Do not mix new and used batteries. Replace all batteries at once.
2. I can’t pair my unit to my DiO application... What should I do?
Slow flashing
Waiting for pairing (see point 4.).
Fast flashing
The doorbell receives the pairing information and
starts to connect to the router
LED off
Standby mode.
Dimming of the
LED
Firmware update.
