Page 2/4
Press button A
❻
or button B
❼
long to exit the manual opera-
tion mode.
Manual operation RF
Pressing button B
❼
short, enters the manual operation for RF
mode.
By pressing button A
❻
, routing runtime telegrams (group
telegrams) will be enabled/disabled. This will be indicated by
LEDs 5 and 6
❺
.
By pressing button B
❼
, routing management telegrams (indi-
vidual addressed, broadcast and system broadcast telegrams)
will be enabled/disabled. This will be indicated by LEDs 7 and 8
❺
.
Press button A
❻
or button B
❼
long to exit the manual opera-
tion mode.
Factory default settings
The following configuration is set by factory default:
Individual device address:
15.15.0
Routing (TP line
RF line):
Individual addressed telegrams:
Filter
Group addressed telegrams:
Block
Routing (RF line
TP line):
Individual addressed telegrams:
Filter
Group addressed telegrams:
Block
Reset to factory device settings
It is possible to reset the device to its factory settings:
Disconnect the KNX Bus connector
❸
from device
Press the KNX programming button
❶
and keep it
pressed down
Reconnect the KNX Bus connector
❸
of device
Keep the KNX programming button
❶
pressed for at
least another 6 seconds
A short flashing of the all LEDs
❷
,
❹
and
❺
visualizes
the successful reset of the device to factory default set-
tings.
ETS database
The ETS database (for ETS 5) can be downloaded from the
product website of the KNX RF/TP Coupler: www.dinuy.com.
ETS parameter dialogue
The following parameters can be set using the ETS.
Description
The first page shows general information about the device.
General settings
Device name (30 Characters)
An arbitrary name can be assigned for the KNX RF/TP Coupler.
The device name
should be meaningful, e.g. “Living Room”.
Manual operation on device
This parameter sets the duration of the manual mode. Upon
completion the normal display mode is restored.
Repeater
Disabled:
Received telegrams will not be repeated.
Enabled:
Received telegrams will be repeated to
extend the RF range.
The KNX RF/TP Coupler can also be used as a repeater. In this
case, the individual address has the form x.y.z, where z must not
be equal to 0. The filter settings in the parameter dialog of the
ETS are ineffective in repeater mode.
