Beijing Dinghengtai Technology Co., Ltd.
Tel:86-10-52679667,57430056
http://www.dingtek.com
E-mail: [email protected]
Room 605, Building Botai B, Nanhudongyuan 122, Chaoyang District, Beijing, China 100102
Page 5
terminal only can resend the connection to the center.
9,The host terminal output control mode settings
Set the output control mode.
There are two ways: oil control mode and the speed control hint mode, the terminal default
oil way
StrValu: the setting value is Ascall code, no fixed length.
When set to "CARON", it can activate the over speed hint way, when the over speed alarm
open, it would output the signal hint. The red line of the terminal would connect with the
alarm speaker or buzzer.
When set to "CAROFF", it can activate the oil way, it means the monitoring center would
send “cut off the oil” instructions, it would use terminal to control the output signal to cut off
the oil way of the car.
11, Short message debugging ways settings
In order to take easy way to debug the terminal and testing the terminal’s working state, the
terminal increase the short message debugging instructions. When you using text messages
to read parameters, you don’t need not to input password, but if you want to change the
machine parameters you have to input the correct password.
Control
1, Remote restart
When the monitoring center remote send the restart instructions, the terminal will
automatically cut off the power and to restart. The directive is mainly used for
communications in normal condition and other abnormal condition, it would cut off the power
of terminal and restart. In order to ensure the terminal can work normally. After restart the
terminal, the mileage statistics will reset
2, Remote controlling oil
This function mainly divided into cut off the oil and supply the oil
The monitoring center allots stop oil instructions, terminal will directly cut off the oil of the
vehicles, the car will shut down.
The monitoring center send the supply oil instructions, the terminal will supply the oil of the
vehicles.
3, Driving mileage initialization
Set the designated vehicles mileage
Miles: 3 bytes, show HEX, the unit is meters, range: 0 ~ 0 xFFFFFF x000000 such as 0
