12
Lower
display
Upper display
meaning
[
,,,F27
]
[
, , , , n o
]
Non functional instrument
[
,,,F28
]
[
s s i o - -
]
Test communication port, see section 8.1 for details
[
,,,F29
]
[
A 8 * *
]
The version number is displayed, and other relevant
contents are displayed in the order of input
[
,,,F30
]
[
r - c a l
]
Refer to the calibration results (calibration
coefficient of each sensor), see Section 6.2 for
details
[
,,,F31
]
[
i n i t 0
]
Used to initialize the instrument, see Section 8.5
[
,,,F32
]
[
d-of
]
Special functions (such as input and
output position adjustment, etc.)
See section 7.6
for details
[
,,,F34
]
[
tst- b c d
]
(only for instruments with BCD output)
Press input, display [B-H *], set to 0: BCD code output,
Set to 1: binary code output, set to 2: BCD code reverse
output
Set to 3: reverse output of binary code
Press input and display [BCD * *] to enter BCD code
output self-test
[
,,,F36
]
[
Prog
]
Manual input process No.6, if you need this function,
please contact us for details
[
,,,F37
]
[
rdP1 000
]
1. Large screen output
Press [Enter] to display [rdp2 000] and set 2 "large
screen output content
The factory default value is 0, which means there is
no output. See section 7.2 for details
5. Speedometer
5.5 P parameter setting
Enter the following steps to set the parameters:
(1) Press and hold the [Pxx] key for about 2 seconds, the lower row of the instrument
will flash [p * *], and the upper row will display [,, * *], (the specific
content depends on the process).Different parameters can be selected for
operation by pressing the key [↑], [↓]. At this t
ime, the label of the current
f parameter will flash in the lower row.
(2) After selecting the corresponding P parameter, press the [Enter] key again
to enter the corresponding parameter modification operation. At this time,
the lower row does not flicker, while the upper row parameter content flashes,
which can be modified by the four keys of [↑], [↓], [→].
(3) After modification, press the [Enter] key to confirm the completion of the
setting, or press [Cancel] to abandon the setting of the current item and exit
to the previous menu.
Note 1: some parameters are set as control parameters by the processSection
5.4The method described in this paper is to log in first. If you have already logged
