9
Fireplace Installation (continued)
4. Lift fireplace, from the bottom
and the handles located on the
back, and insert into opening to
the desired depth.
5. Using a bubble level (supplied)
ensure that the fireplace is level
within the framing. Adjust as
required.
6. Drive four supplied mounting
screws through the four
mounting holes located on the
inside surface of the fireplace
chassis, into wall studs
(Figure 4).
Permanent Heat Disable
The fireplace heater can be
permanently disabled by removing
the electronic jumper on the main
control board. Disable the heater
before any other installation takes
place.
Figure 4
Mounting Holes
To disable the heater:
1. Locate the main control board
(Figure 4).
2. Pull out the electronic jumper
(shunt). The marking beside the
jumper is "HT EN" (Figure 5).
Use two conductor, non-metallic
sheath cable with ground wire
(3 wires total) for the incoming
power supply.
HT EN
Figure 5
Flame
Panel
Main Control Board
