These feet should only be used when it is not intended to fix the appliance to the wall.
NOTE :- When the feet have been fitted, the appliance MUST be positioned against a wall on
a firm surface before building in the storage heater bricks.
DO NOT ATTEMPT TO MOVE THE HEATER, UNDER ANY CIRCUMSTANCES, ONCE
THE BRICKS ARE FITTED
INSTRUCTIONS FOR FITTING
OPTIONAL FLOOR STANDING FEET
MODELS:
WMX/S718N, WMX/S724N, HSX/DA18N & HSX/DA24N ONLY
1.
Remove the outer wrap packing of the heater, ensuring the end packing is left on the heater.
2.
Rotate the heater so as it is upside down and the outer
front is facing away from the installer. See fig 1.
3.
Place an M4 taptite screw as supplied in the fixing kit in
each of the drawn holes A and B. See fig 2A.
4.
Tighten both the screws until they are approximately half
way into the base of the heater.
5.
Taking one of the floor standing feet and viewing as
shown in fig 2B, rotate the foot to position Keyhole A
over the taptite screw located in hole A.
CONTENTS
TOOLS REQUIRED
2 x Floor Standing Feet
Pozi-drive Screwdriver
4 x No. 6 x 3/8” Self Tapping Screws
Electric Drill
2 x M4 Taptite Screws
1 x 2.6mm Ø drill bit
KEYHOLE B
FIG. 2B
TOP VIEW OF HEATER
FRONT OF HEATER
TOP VIEW OF FEET
FRONT OF FOOT
KEYHOLE A
FIG. 1
FRONT OF HEATER
FIG. 2A
TOP VIEW OF HEATER
FRONT OF HEATER
A
B
A
B
