Installation
1.
Remove front louvred panel by removing
three screws on top flange and one below centre of
louvre panel.
2.
Remove the mounting bracket and mark off
the screw positions on the wall or ceiling. Fix the
bracket in position by making the necessary wall
fixings as described under the heading " Special
Instructions on Fitting the Heater to a Wall or
Ceiling”
3.
Locate the heater on the mounting bracket
ensuring that the hexagonal screws are fully
engaged in the slots of the bracket.
4.
It is important that the serrated metal
washer is located between the heater wall fixing
member and the wall mounting bracket. Adjust
heater to the required angle then firmly tighten the
hexagonal headed screws using the 8mm spanner.
5.
Connection to the fixed wiring of the
premises should be done through an adjacent 30
amp double-pole switch.
6.
Connection from the remote control switch
may be carried out. Refer to circuit 1 and 2 opposite
for removal and substitution of wires within the
appliance.
7.
Cable connection should be carried out at
this point. Ensure the supply cables are of adequate
current carrying capacity and are protected by a
suitable fuse.
If the appliance is mounted in a bathroom, the
appliance should be mounted such that no part of it
can be touched by a person using a fixed bath or
shower. An isolating switch must be provided
outside the bathroom or be of the pull-cord type.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
8.
Re-secure front louvred panel.
