www.dimplex.de/en SES EX-EO_en · 05/15/B
EN-5
English
Extenter SES EX-EO
1. Safety Information for the user
NOTE
NOTE
Dear customer,
Read all information contained in this manual carefully.
Keep these instructions in a safe place and pass them
on to any new owner.
ATTENTION!
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience or
knowledge if they have been given super-
vision or instruction concerning the use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user main-
tenance shall not be made by children without
supervision!
Only plug the extender into a fixed mains outlet with
earthing contacts.
Do not use the extender in combination with an ex-
tension cable.
Do not plug the extenders into each other.
Make sure that the mains plug and power cable of
the device you are connecting are undamaged.
Do not open the extender.
The extender must only be used indoors.
Protect the extender against moisture, wetness,
dust, sunlight and other sources of heat.
Never operate the extender beyond its maximum
operating limits (refer to the technical specifica-
tions).
Unplug the device before making any changes
(e.g. changing a bulb).
NOTE
NOTE
Unlock the child lock by a slight tilting movement of the
plug.
2. Introduction
(1) Status LED (2) Info LED (3) Button
The extender acts as an extension of the central unit
and performs the following functions:
Extending the wireless network
The extender receives the signals sent from the
central unit via the existing power line (Powerline
Communication, PLC), converts these to wireless
signals and relays them to the end devices (and
vice versa).
This means that devices installed in locations
which are difficult to reach for wireless signals can
also be controlled from the central unit.
Additional wireless technology.
With the EnOcean extender, for example, the entire
system can be expanded with EnOcean techno-
logy.
Plug with child-proof lock.
ATTENTION!
The extender not a switchable plug!
3. Operation
For PLC and wireless operation, the central unit, ex-
tender and devices have to be “introduced” to each
other. This is the “inclusion” process.
The inclusion process is controlled by the central unit
(refer to the documentation for the central unit).
3.1 Including the extender on the central unit
Plug the extender into a fixed mains outlet with
earthing contacts.
During the boot-up process, both LEDs light up
white for around
3 seconds. After this, only the Status LED remains
illuminated.
Status LED yellow:
Extender not connected to the
central unit.
Status LED blue:
Extender connected to the cen-
tral unit and ready to operate.
Start “Inclusion” mode on the chosen central unit.
Briefly press the button on the extender 3 times.
The Status LED flashes white.
T
he connection is established and the extender is
included on the central unit.
Once it has been successfully included, the Sta-
tus LED lights up blue.
After 10 seconds, the inclusion process can be
ended by pressing the button on the extender
again.
Inclusion can last up to 15 Minutes before timeout oc-
curs.
If inclusion has failed, lower the distance between the
devices and repeat the inclusion process.