MAINTENANCE
WARNING
•
Disconnect all power coming to fireplace
at main service panel before attempting
any maintenance or cleaning to reduce risk
of fire, electric shock or damage to
persons
Light Bulb Replacement:
Light bulbs need to be replaced when you notice a dark section of the
flame. There are two bulbs which generate the flames and embers.
Tool Requirements:
Slot Screw Driver
Bulb Requirements:
Quantity of 2 clear chandelier or candelabra
bulbs with an E-12 (small) socket base, 60 watt rating. Example: GE
60BC or Philips 60CTC.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce the number
of times you need to open the unit to replace light bulbs. Long life
bulbs are recommended to reduce the frequency of bulb changes.
NOTE
•
Allow at least 5 minutes for light bulbs to
cool off before touching bulbs to avoid
accidental burning of skin.
CAUTION
•
Do not exceed 60 watts per bulb.
•
When handling log only apply force to the
ember bed section not directly to the logs.
OPERATION
REMOTE CONTROL
The Optiflame fireplace is
supplied with a radio
frequency remote control (all
models except BF30E). This
remote control has a range of
approximately 50ft. (15.25m),
it does not have to be pointed
at the fireplace and can pass
through most obstacles
(including walls). It is
supplied with one of 243
independent frequencies to
prevent interference with
other units. The frequency
designation is indicated on
the back of the transmitter
(FIGURE 1).
A. Remote Control
Initialization
This procedure is required
every time there is a loss of
power to the remote control in
the fireplace (i.e. power
failure, breaker tripped, main
power switch is turned off)
1. Ensure that power is supplied through main service panel.
2. Access the manual controls, (remove glass doors if applicable)
pull right hand edge of right hand steel curtain towards the
center of unit. (FIGURE 2)
3. Locate manual controls refer to FIGURE 3.
4. Activate main power switch, red indicator light 1 will flash.
5. Press ON button located on the remote control transmitter
(FIGURE 1). This will synchronize the remote control
transmitter and receiver.
FIGURE 1
2
5
