7
CAUTION:
Ensure installation
does not allow fireplace to be in
direct contact with building vapor
barrier or insulation and meets all
local building code.
!
NOTE:
A dedicated, properly
fused 13 Amp circuit is required,
rated for the appropriate voltage
(230-240V).
WARNING:
Construction
and wiring must comply with
local building codes and other
applicable regulations to reduce
the risk of fire, electric shock
and injury to persons.
WARNING:
To reduce the risk
of fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING:
To reduce the risk of
fire, do not store or use gasoline or
other flammable vapors or liquids in
the vicinity of the heater.
1. Select a location that is not
susceptible to moisture and is
away from drapes, furniture and
high traffic.
2.
Unpack the fireplace and
hardware from the box.
!
NOTE:
Leave the front glass
and partially reflective glass,
safely, in the box until the time you
Fireplace Installation
are ready to install it.
3.
Store the fireplace in a safe,
dry and dust free location until
you are ready to install the
fireplace.
Installation
CAUTION:
Two people will be
required for various steps of
this procedure.
This design of this unit allows three
options for installation:
partial
recess
,
flush mounted
or
sub-
surface
mounted.
CAUTION: Sub-surface
mounting should be limited to
½
in. (12 mm) to ensure adequate
air flow of heated air out of the
firebox area.
1. Prepare a wall with a framed
opening of 16 in. (40.6 cm)
high,
•
XLF50 - 50 ⅝ in. (128.7 cm)
•
XLF74 - 74 ⅝ in. (189.7 cm)
•
XLF100 - 100 ⅝ in. (255.7
cm) wide, with a bottom sill
that is a
minimum
of 4 in.
(10.2 cm) deep. The sill can
be constructed to support the
front of the unit to allow the
power supply wires to easily
be run behind or flush with the
back of the unit and a pass thru
