4
d. when ambient temperature is above 27
℃
, it will automatically set
humidity level at 50%
TANK FULL
If this indicator illuminates, it means tank is full of water, and unit will operate
with fan only (The compressor will stop running automatically, until the tank
was empty)
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than
the ambient humidity.
2. Drain the water in the water storage tank when the water in the tank is
full and the water level indicator light illuminates. And then install the
empty water tank back to its position, so the unit can continue its
operation.
3. When the unit stops, you have to wait for 3 minutes before you can
restart the unit to protect the compressor from damage.
4. The operational temperature range for this unit is 5-32
.
℃
5. If the dehumidifier does not start (the operational light does not
illuminate) or the dehumidifier makes intermediate stop on unknown
reasons, please check the plug and power supply for poor connection. If
the plug and power supply are in normal condition, wait for 10 minutes
and restart the unit (because take about 10 minutes to reposition). If the
unit still does not start in 10 minutes, please contact your local distributor
service station for repair.
6. When the dehumidifier is in operation, the running compressor will
produce heat and make the room temperature higher. This is normal
condition.
5
7
．
Defrost light on is to indicate the operation of defrost is start. During this
operation mode, compressor will be switched off and air motor will be
turned on.
DRAINAGE INSTRUCTION
The extracted water can be collected by water tank, or drained continuously
with a PVC hose (not available):
USE OF WATER TANK:
When the water full indicator illuminates, the tank is
full, and the compressor and the fan will stop
operation, please empty the water tank:
1. Remove the water tank as Fig 01. and empty it.
2. Insert gently the water tank into the unit reach to
its original position.
CONTINUOUS DRAINAGE
1. When you want to use this function, please pull
out the water tank, and plug the discharge water
pipe in “Water out hole” (See Fig.02). Replace
the water tank into the unit, then you can
operate the unit.
Filter Removal
•
The filter can be removed from its slot by
gripping the filter handle and sliding it out from
the back of the appliance.
• Every 2 weeks, remove the filter and clean it
with warm water, below 40°C. Allow it to dry naturally and then replace.
Fig 01
Fig 02
