Quick Start Guide
FX Wall Mounted Fan Heaters
QS015
This guide is for quick reference only. Refer to the FX installation and operating instructions for further information
FX20V
Dimplex UK Ltd, Millbrook House, Hedge End, Southampton, SO30 2DF. For further assistance please contact Dimplex customer services on 0845 600 5111. Web-site: www.dimplex.co.uk
On/Off indicator
Indicator will glow red when heating
Pull cord switch
Pull the cord to switch the heater ON and pull the cord
again to switch the heater OFF
FX20VE (runback timer)
On/Off indicator
Indicator will glow red when heating.
Pull cord switch
Pull the cord to switch the heater ON and the heater will
run for 15 minutes* and then automatically switch off. To
restart the heater for a further 15 minutes pull the cord
twice.
To switch the heater off before the timer
expires pull the cord once.
*Timer is factory preset at 15 minutes but can be adjusted to run for any
time period from 5 – 155mins, please refer to installation and operating
instructions for further details
FX20VL
Thermostat
Turn thermostat dial to appropriate position to
give comfort level required. Heater will switch on
and off as necessary, and a higher setting will
make the room warmer.
On/Off indicator
Indicator will glow red when heating
WARNING:
A clearance of at least 250mm must be maintained from either side of the heater, 280mm from the top of the heater to the ceiling
and must be installed 1800mm from the floor
DO NOT COVER
or obstruct the air inlet or outlet grilles.
PLEASE REFER TO THE OPERATING AND INSTALLATION INSTRUCTIONS FOR FURTHER SAFETY ADVICE.
