5
Pre-Installation
The upper covers of the appliance are not made to
withstand force and should not be used for
handling purposes.
Non-permitted transport positions:
Permitted transport positions:
No other transport position is authorised
5 Pre-Installation Advice
5.1 Handling
Thank you for choosing this product. The Edel Air
Source Heat Pump water heaters are specified with high
quality, immersion heaters for fast reheat times. They
boast 50mm of low GWP insulation foam, together with
100% recyclable stainless steel inner components and a
hard wearing outer shell manufactured from completely
recycled materials.
Note: This product has been designed
specifically for the purpose of delivering
heated, domestic and sanitary hot water as part
of a pressurised water heating system. The
package is provided with fittings that comply with
Section G3 of Building Regulations.
3 Introduction
If tipped, the centre of gravity will shift
towards the top: handle with care.
Risk of tipping/falling
Do not drop
or lower suddenly
4 Scope of Delivery
Table 1: Scope of Delivery for Edel Water Heater
* These items are supplied factory fitted
Please read the following section carefully before
commencing installation. If in any doubt, please call the
appropriate help desk. Disregarding the instructions given
in this manual in its entirety and any relevant regulations,
standards and codes of practice will void the guarantee of
this product.
Please note that handling, installation and use of this
product is subject to the Health and Safety at Work Act.
If the unit is not installed immediately, it should remain
in its protective packaging with all pipe protectors/end
caps applied to prevent damage and dirt deposit inside
the water heater and the coil.
i
Dimplex cannot take responsibility for
ensuring safe operation of the appli-
ance outside of the scope of intended
use.
5.2 Unpacking
- Remove plastic cover and cardboard packaging.
- Remove corner protection pieces, ensuring that all
nails and staples are taken out.
- Remove protective film from all parts of the appliance
and from the bag of accessories which you will find in
the transport bag.
- Without tilting the appliance, use an appropriate tool
to remove the screws from underneath the pallet.
Keep the transport bag out of reach of
children (risk of suffocation).
Scope of delivery
Cylinder volume
200l
270l
Cylinder with 1.5kW immersion *
1
1
T+P valve *
1/2”, 7bar/90°C
Inlet control group
consisting of:-
- in line strainer
- 3 bar PRV
- 6 bar ERV
- non-return valve
- balanced cold wa-
ter supply port
- connection for
expansion vessel
Expansion vessel
with fixing kit and
connection hose
19l[Pre-charge
pressure 0.3MPa
(3 bar)]
Tundish
15mm/22mm
Installation & User
Instructions x 1
Terms and condi-
tions x 1
Transporting the appliance in a
horizontal position may lead to
irreparable damage to the
components of the heat pump
!
All other transport positions are
PROHIBITED
!
