Display LED
Can be switched off temporarily by pressing the DISPLAY button on the rermote or by pressing and holding
the SPEED
button on the control panel for more than 3 seconds, the display will light up again once any
control button is activated.
Adjusting the Angle of Air Output
.
The Tower Fan can be manually adjusted to change the direction of the air flow, with the Tower vertical
the air comes out horizontally, simply apply pressure backwards at the top of the Tower and the angle will
change until it reaches its limit at an angle of approximately 30° to the vertical with the air flow now directed
upwards from the horizontal. Applying pressure forward to the top of the Tower will readjust it back to its
vertical position again. (See FIGURE 5).
Cleaning and Recycling
WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE APPLIANCE
The fan should be cleaned at least once every two months as dust may accumulate on
the rear grill cover and wind wheel, which would affect performance. Do not use deter
-
gents, abrasive cleaning products or polish of any kind on the appliance. Wipe with a
dry cloth to remove dust and a damp cloth (not wet) to clean off stains. Be careful not
to allow moisture into the appliance. Use a vaccum cleaner to remove any fluff which
does accumulate.
For electrical products sold within the European Community. At the end
of the electrical products useful life it should not be disposed of within
house-hold waste.Please recycle where facilities exist. Check with your
Local Authority or retailer for recy-cling advice in your country.
(Figure 5)
