Unwrap the cable and plug in the product, it will beep twice to signify that it is connected and remain in standby mode.
Standby LED will be active.
Standby
The standby button
, see 1 Fig. 2 and 13 Fig. 3, must always be pushed to start the product, once the product is
started, it defaults to
operate in Normal mode at Low speed with the Low speed LED and the power on LED both
illuminated, no other function will operate unless the relevant button is pressed. Pressing the standby button again
during any mode of operation will return the product to standby mode. When the product is switched back on
it will remember fan speed and oscillation setting and will turn back on in Normal Mode. Note: After one minute product
indication lights will turn off, light will come back on when any button is pressed.
Mode
Pressing Mode
button, see 3 Fig. 2 and 12 Fig. 3, when unit is on will cycle through product modes. Product will
cycle through Natural Mode, Sleep back and back to Normal Mode with each button press. The relevant LED light will
indicate when Natural and Sleep mode is selected. Only the selected fan speed LED will light in Normal Blower mode.
Normal mode:
The fan speed selection button , see 2 Fig. 2, is used to manually select Low , Medium or High
speed fan operation. The relevant speed indication LED will light as the appliance changes between speeds.
Natural mode:
In this mode the fan will automatically change speed to simulate natural variances in the speed of
the air flow to give an experience similar to a natural breeze. In this mode you can use the speed selection button to
cycle between low, medium and strong breeze.
Sleep mode
: In this mode
the fan speed will continuously vary speed to assist in keeping cool at night when asleep.
You can select 3 different running patterns in this mode by using the Speed Selection button;
•
- Varies between high, medium and low speed.
•
- Varies between medium and low speed.
•
- Operates at low speed.
Runback Timer
By pressing
button, see 4 Fig. 2 and 11 Fig. 3, the fan can be set to operate continuously with currently selected
settings for a set time before turning off. Time intervals of 1 hour, 2 hours, 4 hours or 8 hours can be selected. The
selected period will be indicated by its LED light which will remain on for the selected time, when the selected operating
time has run out the product will switch off automatically and go into standby mode.
Oscillation
The oscillation button , see 5 Fig. 2 and 9 Fig. 3 can be pressed while the product is operating to activate oscillation.
The product can be set to oscillate at an angle of 30°, 90°, 180° or 360°, the angle selected will be indicated by the
illumination of the relevant LED. When selected fan will oscillate over and back through the selected angle to provide
a wider cooling effect. When 360° is selected the fan will constantly rotate clockwise.
If the fan speed varies randomly this means NATURAL mode is selected, which simulates natural breeze
conditions. THIS IS NOT A FAULT.
To activate normal mode again use the mode button to cycle through modes to Normal mode.
Remote Control Use
To activate the remote control release and slide out the battery holder from the bottom back of the remote control
handset see Fig. 5, install the 3V CR2032 button battery cell into its location ensuring the positive and negative pole
are as indicated on the label on the back of the remote and reinstall the battery holder completely.
The remote control will only operate the product if it is in direct line of site and within a distance of 6 meters from the
product. If it fails to do so under these conditions and the product has been in use for some time, please check the
battery is not depleted before taking any other action.
Operating Instructions
Fig. 5
