9
Mounting
Figure 3
Installation
Heater
3
Securing hardward:
Anchor
Screw
The DIRP15A10GR heater package contains the following:
910mm(35.4") Min. to surfaces (ie table tops,ect)
USA
:1800mm(72") Min.floor
CANADA
:2400mm(96") Min.floor
3000mm(118.1") Max.from floor (recommended)
1500mm
(
59
.
1
")
Min.
1500mm
(
59
.
1
")
Min.
(recommended)
from both ends
300mm
(
11
.
8
")
Min.
(recommended)
from both ends
Tools required:
• #2 Philips Screwdriver
• Pencil
• Level
• Drill with 6 mm or 15/64" Drill Bit
• Hammer
• Ladder
1. Carefully select the installation site, ensuring that all minimum clearances and safety requirements have
been met. For a studded wall, the holes must be aligned with the wall framework where possible. Use a stud
finder to make sure as many holes as possible will be aligned with the wall frame/studs.
2. Position the wall-mounting bracket flush against the wall and mark the location of 1 of the mounting holes.
3. Place the level onto the top of the wall-mounting bracket. Level the wall-mounting bracket, and mark
the 2 other mounting screw locations on the wall, ensuring that the wall bracket remains level.
WARNING
• The heater must be installed on a vertical wall. The heater is equipped with a tilt switch, which will prevent
the heater from operating if it is installed on a sloped wall. The heater must only be operated in a horizontal
position with a maximum 2° slope.
• Never install the appliance on a combustible surface (plastics, nylon, carton, etc.)
• The installation structure and hardware must be able to hold 5 times the weight of the heater.
• Never install or reinstall the heater assembly using mounting holes/screws that are loose. Always ensure
the heater is firmly secured to mounting bracket and the mounting bracket is firmly secured to its mounting
surface.
• Do not install the mounting bracket on the ceiling. Do not angle the heater toward the ceiling.
Figure 3
shows examples of correct and incorrect installations.
