6.2 Hand Washing
Detach and Remove the Controller before Cleaning the Throw.
Never Use Hot Water
as the Heated Throw may shrink and will void your
warranty.
DO NOT
Pre-Soak or use stain removers of any kind which contain Bleach. This
includes any of the Oxy pre-soakers or Stain Removers
•
After removing the controller, place the Heated Throw in cold water (bathtub or
large laundry tub is ideal) mixed with either a natural wool detergent or with mild
soap flakes.
•
Soak your Heated Throw for approximately five minutes, and then gently
squeeze the soapy water through the Heated Throw.
•
Rinse your Heated Throw thoroughly with clean cold water until no more suds are
visible, and allow water to drain off the Heated Throw.
Do Not Wring or Spin Dry the Heated Throw. Drip Dry Only
•
Refer to the section “
Drying
” for drying instructions.
With normal use it is recommended that you hand wash your Throw once a year.
6.3 Drying
•
Spread the Heated Throw out on a clean surface (e.g. a large table) to dry in a
shady area.
•
Your Heated Throw can also be dried on a clothes line provided the majority of
water has been drained off, providing the Heated Throw is not creased or folded
and as long as pegs are not used on the element areas of the Heated Throw. i.e.
Hang from the edge of the Throw only.
Note
: The Heated Throw must be thoroughly dried (including controller socket)
before using.
DO NOT WRING OR SPIN DRY THE HEATED THROW. DRIP DRY ONLY.
Page 10 of 15
Rev 1