– 7 –
d) Fan: turned on.
e) Temperature setting: the default temperature setting is 25ºC.
f) Fireplace display: turned on,
lights up.
g) ECO: turned off,
lights off.
4. In heating mode, press
to shift the power between low and high power level.
a) Low power:
lights up.
b) High power:
lights up.
5. In heating mode, press
to enter ECO mode,
lights up, press it again to
quit this mode.
a) ECO mode: the default temperature setting is 22ºC. When the room
temperature is lower than 18ºC, the machine works in high power: when
the room temperature is between 18ºC and 22ºC the machine works in low
power. When the room temperature is above 22ºC the heating element will
turn off.
b) When the ECO function is operating, the
button is not active.
c) When the room temperature is above 22ºC the heater and oscillation function
will also be turned off.
6. In heating mode, press
to turn on/off the oscillation function,
will light
up/off accordingly.
7. In heating mode, press
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
button to set the timer.
a)
Timer: press
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
key,
and will display, press +/-
key to set the timer (within a range of 0-24 hours), the timer will increase or
decrease by 1hr increments.
b) Entering the timer mode by pressing
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
does not change
the timer settings. But you can set the timer by pressing the +/- key. After no
operation for 5 seconds, the time that you have set will be saved.
c) When the timer turns to the value “0”, the device will then turn off and enter
into standby mode.
d) If the timer is set as “0”, it means that no timer is set.
8. In heating mode, press
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
button to set the temperature.
a) Temperature setting function: press
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
key,
and
SETºC will display, press +/- key to set the temperature. The range of the
temperature is from 15°C to 35°C, and can increase or decrease by 1°C
increments.
b) Entering into the temperature settings by pressing
Page 5
Control panel
Display panel
Remote control operation panel
or
Page 5
Control panel
Display panel
Remote control operation panel
keys
does not change the temperature settings. You can set the temperature by
pr/- key. After no operation for 5 seconds, the temperature that you
have set will be saved.
14064_DHCER20FE Manual_V2.indd 7
7/12/17 4:25 PM
