7
Heater Installation
HEATER LOCATION AND
CLEARANCES
The heater is intended for flat
use on a hard floor, table top,
desk or on shelf, and the like, or
suspended on a wall or ceiling
by means of provided hanger
bracket.
When suspended from wall or
ceiling, heater should be located
along outside walls to provide
perimeter air circulation.
The discharge air should wipe the
walls without blowing directly on
them. (Figure 2)
If heater is to be tilted on
horizontal axis after mounting -
ensure a minimum clearance of
26.5 inches (67 cm) between floor
and bottom of heater. also, when
mounted to ceiling, ensure a
minimum clearance of 3.5 inches
(9 cm) from ceiling to top of
heater. Ensure the air discharge
is parallel to or away from walls.
INSTALLATION WITH WALL/
CEILINg HANgER BRACkET
!
NOTE:
To prevent personal
injury always use a licensed
electrician to install new outlets or
circuits.
use of the hanger bracket allows
the unit to be rotated approx 45°
in each direction from centre,
and tilted in a range of 45° while
suspended from a wall or ceiling.
!
NOTE:
The hardware for
mounting the hanger bracket to
the wall or ceiling is not included.
CAUTION:
When turning
and/or tilting the heater do not
block the exhaust opening.
The following steps are shown in
Figure 3.
Locate a stud or other
1.
suitable support and install
hanger bracket on wall or
ceiling. select a location
where the control knob can
be easily reached.
Insert carriage bolt into
2.
square opening of heater
DISCHARGE
ouTsIDE WaLL
FIgURE 2
