As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows:
Connect the
BROWN
wire to the terminal marked ‘
L
’ or
coloured
RED
. Connect the
BLUE
wire to the terminal
marked ‘
N
’ or coloured
BLACK
.
Note:
‘
L
’ or ‘
N
’ must not
be connected to the
EARTH
terminal marked ‘
E
’ or ‘ ’ or
coloured
GREEN
or
GREEN AND YELLOW
.
If in doubt, consult your electrician.
Using the Heater
Main Elements
-
See Fig 1.
1. Power indicator light
2. Standby thermostat
3. Air outlet grille
4. USB charge port
5. Safety tilt switch
Standby Thermostat -
see Fig. 2
The heat output is controlled by the
thermostat, according to the local
area temperature.
Turn the thermostat knob fully
clockwise to maximum setting
initially. When the area is warm
enough, reduce the setting slowly
until the heater just clicks off.
The heater will now cycle on and off to maintain your local
area temperature. An audible click may be heard when the
thermostat operates - this is normal.
Note:
If the heater does not come on when the thermostat
is at a low setting, this is normally because the local area
is warmer than the thermostat setting and is not a fault.
Position ‘ ’ will put the heater into standby mode (unless
the temperature is approximately 5°C). This is a special
setting to enable the product to be used as a charger
throughout the year.
Safety - overheat protection and tilt switch
For your safety, this appliance is fitted with a thermal cut-out.
In the event that the product overheats, the cut-out switches
the heater off automatically. To bring the heater back into
operation, remove the cause of overheating, then turn off
the electrical supply to the heater for a few minutes.
When the heater has cooled sufficiently reconnect and
switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
The heater is also fitted with a tilt switch, so in the event
the heater gets accidentally knocked over the product will
not operate.
USB Charge Port
This product also has the facility of a USB charge port which
supplies a 5V 2.1A supply. Please ensure that your device
is suitable before connecting to the USB port. It is designed
to charge the majority of tablets and smartphones.
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish
of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains. Be careful not to allow moisture
into the heater.
Ensure that dust or fluff does not accumulate inside the
heater as this could lead to overheating of the element.
Use a vacuum cleaner to remove any fluff which does
accumulate.
Recycling
This marking indicates that this product should
not be disposed with other household wastes
throughout the EU. To prevent possible
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resourses. To return your used
device, please use the return and collection systems or
contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
After Sales Service and Extended Guarantee
Your product is guaranteed for 1 year from the date
of purchase. The 1 year guarantee is extended for an
additional 2 years when you register the product with
Dimplex, within 28 days of purchase. If you do not register
the product with Dimplex within 28 days, your product will
remain guaranteed for 1 year only.
Within the extended guarantee period we undertake to
repair or exchange this product free of charge providing:
a) Proof of purchase such as a sales receipt should be
provided, showing that the appliance was bought within the
36-months prior to registering the defect/fault.
b) The appliance was correctly installed and operated in
accordance with the manufacturer’s instructions and used
solely for domestic purposes.
c) The defect/fault was not as a result of accident, misuse,
unauthorised modification or inexpert repair
Your rights under this guarantee are additional to your
statutory rights, which in turn are not affected by this
guarantee.
To validate your extended guarantee register with us online
at http://register.dimplex.co.uk
N.B. Each qualifying product needs to be registered with
Dimplex individually.
Please note that the extended guarantee is only available
in the UK and Ireland.
If after following these steps your product still does not
operate you should return it to your point of purchase.
Please do not return a faulty product to us as this may
result in loss or damage and delay in providing you with a
satisfactory service.
Fig. 2
