1. Place the fan on a firm level surface. Connect the plug to a power supply and
switch on the power.
2. Turn the fan
ON
by rotating the speed control knob on the motor housing in
clockwise direction.
3. The fan has 3
SPEEDS
to choose from, "1" - Low, "2" - Medium, "3" - High.
4. The airflow direction can be adjusted upward/downward by lifting up or pressing
down the motor housing.
NOTE:
Only adjust the fan head when the unit is
OFF
. Be careful not to insert your
fingers through the guard.
5. Push the oscillating knob on the motor housing down to start
OSCILLATION
. Pull
the oscillation knob up to stop
OSCILLATION
.
6. Turn the speed control knob anti-clockwise to the “0” position to turn the fan
OFF
.
Operation
Assembly
Lastly, attach the fan head to the motor - refer to Fig. 3 & the instructions below:
1. Remove the protective sleeve from the motor shaft (12) and the four fixing
screws from the motor housing. Attach the rear guard (4) to the motor housing
(9) using the four screws you just removed. Ensure the handle is at the top.
2. Place the fan blade (3) over the motor shaft (12) and tighten the fan blade
screw completely, ensuring that it tightens against the flat part of the motor
shaft.
3. Remove the front guard screw and nut (2, 5) from the front guard and release
the guard retaining clips (14) around the outside edge outwards.
4. Hang the front guard (1) by its hook over the top of the rear guard (4). Bring the
front guard down to meet the rear guard and fit the guard screw (2) through
the holes in the bottom edge of the guard and tighten with the nut (5). Finally
push the clips inwards until the front guard is attached to the rear guard.
9
8
