7
Installation
WARNING:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING:
Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING:
Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:
To reduce the risk
of fire, do not store or use gaso-
line or other flammable vapors or
liquids in the vicinity of the heater.
1. Select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
CAUTION:
High temperature,
risk of fire, keep electrical
cords, drapery, furnishings,
and other combustibles at
least 3 feet (0.9 m) from the
front of the heater.
2. For ease of electrical hook
up you may wish to locate
the fireplace near an existing
outlet.
!
NOTE:
A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not essen-
tial in all cases. A dedicated circuit
will be required if, after installa-
tion, the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating. Ad-
ditional appliances on the same
circuit may exceed the current
rating of the circuit breaker.
3. Store the fireplace in a safe
dry and dust free location.
!
NOTE:
The dimensions of the
fireplace are 44 in. (1118 mm)
wide x 34 in. (883 mm) high x
11 5/8 in. (295 mm) deep. The
fireplace does not require any
additional venting.
LOGSET LED LIGHTS
Wiring
