Operation
Controls
The switches provide a choice of heat settings, The appliance is in standby mode
when the mains lead is plugged in. This is indicated by the red neon behind the flame
effect screen. The two selector switches are in the ON position when the side with
the markings on (i.e. I, or II) are pushed in.
1. Selector switch 1 (0) - Controls the electricity supply to the appliance and
flame effect. Press for ‘ON' & ‘Standby’. If both selector switches 2 and 3 are in
the OFF position, the product works on flame effect only.
2. Selector Switch 2 (I) - Provides 750W heat output.
3. Selector Switch 3 (II) - Provides 1.5kW output with switch 2 also pressed.
Thermostat (T)
In order to maintain a certain room temperature, set the controller to ‘max.’. Operate
the appliance at full power until the required room temperature is reached. Set back
the thermostatic controller until the appliance switches off with an audible “click”.
This temperature will be kept almost constant by the thermostatic control switching
on and off automatically. Please note that the appliance can only be switched on
when the thermostat setting is higher then the room temperature.
9
