Controls - see Fig. 2
These switches provide a choice of heat settings, The appliance is in standby mode when the
mainslead is plugged in. This is indicated by the red neon behind the flame effect screen. The
two selector switches are in the ON position when the side with the markings on (i.e. I, or II) is
pushed in.
Selector switch 1 ( ) Controls the electricity supply to the
appliance and flame effect. Press for ‘ON’
and ‘Standby’. If both selector switches 2
and 3 are in the OFF position, the product
works on flame effect only.
Selector Switch 2 (I) Provides 1kW heat output
Selector Switch 3 (II) Provides 2kW output with switch 2
Thermostat (T) - see Fig. 4
In order to maintain a certain room temperature, set the controller to ‘max.’. Operate the
appliance at full power until the required room temperature is reached. Set back the thermostatic
controller until the appliance switches off with an audible “click”. This temperature will be kept
almost constant by the thermostatic control switching on and off automatically. Please note
that the appliance can only be switched on when the thermostat setting is higher then the room
temperature.
Remote control - see Fig. 3
The maximum range of use is ~ 5metres.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for correct operation.
Battery information - see Fig. 3
1. To activate the remote control remove the battery isolation strip, which is used to ensure your
remote control reaches you fully charged.
2. Remove the screw, follow the instruction on the back of the remote to release the battery
housing. Slide the battery cover open. Install Lithium battery in the battery holder. The positive
(+) side of the battery faces up. Close the battery cover and replace the screw
3. Only use CR2025 or CR2032 size of batteries.
Discard leaking batteries
Dispose of batteries in the proper manner according to provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all
the batteries are not replaced at the same time, if disposed of in a fire, or if an attempt is made
to charge a battery not intended to be recharged.
Operating The Product
