Installation Guide
（ AP6528 ）
Surface mounted
3. Place the aluminum profile on the stair step which
to be installed, drill a few holes in the mounting
groove of the profile with a ∮5mm diameter and drill
directly into the step about 30mm deep.
4. Remove the profile and insert the expansion anchors
into the small hole of the steps.
6. Pinch the plastic strip, insert it into the profile
mounting groove, and press it flat.
5. Then put the corresponding aluminum profile
back on the original step and fix it on the step
with screws.
1. Attach the strip light to the inner bottom of the
aluminum profile, and then cover with the PC cover.
2. Assemble the two end caps at the two ends of
the aluminum profile with screws.
7. Finally, connect the DC cable of the profile to
the power supply which comply with the standard
requirements and the installation completed.
