USER MANUAL
OPIA
LAST UPDATED: 2/12/2016
11
Installation of the handlebars continued...
ASSEMBLY—HANDLEBARS
Locate the handlebar clamp, this can be seen in the top left picture. Insert the
handlebar stem into the handlebar base. One side of the handlebar is grooved so
that you cannot insert it the wrong. Though check that the cables are not twisted
before insertion.
Insert the handlebar to the desired height ensure that the engraved maximum
handlebar height is not visible. (insert them below the clamp). The maximum
handlebar height markers are shown in the top right picture. Close the clamp as
shown in the bottom two pictures. If this is too hard or two easy to close you
should adjust the tension of the clamp by tightening the thumb screw while the
clamp is open. This will ensure that the clamp is firmly closed and no nuisance
movement will occur.
