9
3.4.4 Monitor System Malfunction will occur if the display does not receive
a signal from a transmitter(s) in the tire(s) for more than 30 minutes*,
the display screen will display as dashed lines “- - -” .
NOTE:
When the dash lines
”- - -”
appears, it will not be dismissed from
the display even if you restart the unit. When the receiver
(display unit) receives an updated signal from the transmitter(s),
the dashed lines will disappear.
If you are not receiving a signal from the transmitter(s), verify the
following conditions.
1. Power off the display unit and restart the system. The system will
return to normal monitoring after properly receiving signals from
the transmitter(s).
2. Check your antenna connection. Verify the center coax pin has not
become dislocated from the antenna.
If the display unit is working properly and it still does not receive
a signal from the transmitter(s), then the transmitter(s) and ID
chip(s) must be replaced simultaneously.
3. “Er” indicates there is no chip in the position, the chip is not
correctly inserted into the display or the chip is not functioning.
