CAT5 KVM Module Installation
(DS-72216, DS-72217)
Connect DB 37PIN to LCD Console, similar to VGA KVM module.
To install a Cat 5 KVM module, refer to the following diagrams and do the following:
1.
Plug your USB keyboard and mouse into the USB console port if 2nd console needed.
2.
Use a set of CAT5e/6-wire connectors to plug into any available CAT5 Port on the
switch. Maximum CAT cable length support 60m.
3.
Plug a CAT5e/6-wire connector into the CAT5 connector on the Dongle module of
the KVM, and connect the corresponding VGA video connector, USB or PS/2
connector of the Dongle cable to the corresponding port on the PC.
4.
Plug the power adapter supplied with this package into the AC power source, and
plug the other end of the power adapter into the power jack on the switch.
5.
Connect the network cable to the IP port of the IP module. (Optional)
6.
Turn on the computer.
Note:
1.
Make sure that all plugs are connected to the same group of KVM
connection port jacks (all connected to Port1, or all connected to Port2).
2.
The IP module is an optional module of the product. If the product you
purchased does not include the module, please ignore the related operation
in Step 5.
3.
Before using the IP module, please make the appropriate configuration and
network debugging after the access to the network you want to connect, or
may fail to connect because of normal remote control. (Refer to the manual
of the IP module product manual for how to use and debug the IP module.)
4.
LCD KVM conversion module is divided into two types: PS/2 and USB port,
you can connect your computer to choose the appropriate conversion
module to use.
5.
Make sure you are connecting to a computer and LCD KVM switches have a
good grounding protection altogether, or it may produce a video display
problems
6.
For display problems caused by transmission distance, electromagnetic
interference, common ground, etc. It is recommended to use Category 6
shielded network cable to connect and try to improve the display effect