5.
Switch the unit between CM and Inch
The height unit can be switched between CM and Inch, check
the proceed as follows:
a.
Press the "M" and "1" at the same time for 3 seconds.
b.
Display started flashing and read "C-E".
c.
Press "1" within 10 seconds, the display show "C", and
switched the unit to CM; Press "2", the display show "E",
and switched the unit to "inch".
d.
The display stopped flashing, and the switch
the unit
between CM and Inch
is complete.
6.
Setting the LED retracted height
Press the DOWN button on the memory controller until the frame
reaches its lowest position. Measure the height of the frame from
the floor and see if the height showed on the LED display does
match your measurement or not, if you need to revise the height
which showed on display, follow these steps to set:
a.
Press and hold the DOWN button (about 5 seconds)
until the LED displays the flashing starting height.
b.
Press the UP or DOWN button to increase or decrease
the height (1 unit / click).
c.
Then press "M" and stop flashing, your desk is now ready
to use.
Note: the LED display has a 0.1 tolerance.
7.
Trouble Shooting
Below are the possible errors which can be displayed. The errors
will only be displayed when a button is pressed.