Digitroll DMS 06, Instruction Manual, Page: 5 / 12

INSTALLATION
5
INSTALLATION
MONITOR LOCATION
The monitor has to be mounted in the compartment at a well visible place with
the attaching clip being in lower or upper position using 2 plate screws. Avoid
direct sunlight to reach the display. The most favourable location for the
monitor is right under the compartment roof.
•
The monitor is to be connected to the 12V system of the power machine
behind a minimum 1A fuse with regard to polarity (red = positive, blue =
negative). The wire between the connection point and the 12V
accumulator of the power machine should be as short as possible.
•
Connect the sensors’ extension cable to the monitor.
•
Do not share power supply with devices that may cause interference (fans,
magnetic valves, etc.).
•
Welding works are only allowed when both power cables of the monitor
are disconnected from the tractor’s electronic system.
CONTROL DEVICE
DMS 06 PLANTER MONITOR
1 2 3 4 5 6 ROWS
AUTO OFF
sec
TEST
P
OWER
OUT
DIGITROLL
S tring Circuitry
0,25 0,5 0,75 1 1,5 2
INTELLIGENT SENSOR TECHNOLOGY
Horn
ON and TEST button
(searching seed
sensors, checking
dust level)
Stand-by signal
(red light)
Switched on, 12V OUT= continuous light
Sensor search
= darkens for a short time
Cable short = dark during operation
Switched off = dark
error = red light
Selectable time
intervals (0.25 – 2 sec)
Number of seeder
elements (1-6)
Adjusting sensitivity of
error indication
(max. time period of
seed shortfall)