©2007 Digitrax, Inc
www.digitrax.com
5
independently control each loco with a unique address. Digitrax decoders are
shipped with CV01 (AD2), the two digit address, set to 03. Following is a brief
description of how to change the decoder address with a Digitrax DT series
throttle. See your Starter Set Manual for complete programming instructions.
1 Place the loco on the programming track. Go into Program Mode on your
system. On DT400 press
PROG
. On DT300, DT100 & DT200 press
RUN/STOP
&
FN/F0
.
2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT300 &
DT400). (Ad for DT100 & DT200, see your Starter Set manual for 4 digit
instructions).
3. Use your throttle to choose the address you want to set up for the decoder.
4. Complete address programming. On DT400 press
ENTER
. On DT300,
DT100 & DT200 press
SEL
.
Note:
CV29 must also be programmed to enable 4 digit addressing, this is
done automatically by the DT300 & DT400 but not on earlier throttles.
4
45
50
0 C
Ceem
meetteerryy SSttrreeeett
T
T
7
77
70
0--4
44
41
1--7
79
99
92
2
N
Noorrccrroossss,, G
GA
A U
USSA
A 3
30
00
07
71
1
FF
7
77
70
0--4
44
41
1--0
07
75
59
9
w
ww
ww
w..ddiiggiittrraaxx..ccoom
m
EE
ssaalleess@
@ddiiggiittrraaxx..ccoom
m
