Notes:
l
The detector responds with a signal when it detects most valuable metal
objects. If a signal does not repeat after you sweep the search coil over the
target a few times, the target is probably junk metal.
l
False signals can be caused by trashy ground, electrical interference, or large
irregular piece of junk metal.
l
False signals are usually broken or non-repeatable.
Using BACKLIGHT
In dark area, you can use BACKLIGHT for better searching. Press
VOLUME/BACKLIGHT button for about 2 seconds to turn on the backlight. Long
press it again to turn the light off.
Note:
l
To save power, the backlight will turn off automatically after 10 minutes.
l
As the light consumes more power, it’s better to turn off the backlight in
normal environment.
PP (PINPOINT)
After you find a metal object, you can use PP to pinpoint the target.
(1)
Press PP button, “PP” on LCD flashes. When LCD displays steady “PP”, you
can start to move the search coil slowly above the sound area. If the
detector finds the target, it sounds a tone. Also the digital value of the
target and depth are displayed on LCD.
(2)
Press PP button again. After steady “PP” displays, sweep the search coil,
keeping the same distance of search coil, sound disappears. Closer the
search coil to the sound area, the detector sounds again.
Repeat the above steps until the detector displays the constant signal where the
location of the target is.
FACTORS THAT AFFECT THE DETECTING
It’s difficult to have an accurate detecting result. Sometimes the detecting may
