If you choose to run the BP-8 into a Bi-Amp system. You are given the option of using the Hi-Lo output set up which allows you to set the
Cross-Over frequency at which the BP-8 will route the output frequencies to either the High or Low Outputs. The Procedure selecting this
output is as follows:
BP-8 Valve into a Bi-Amp System Using the Hi-Lo Outputs
To select the High-Low Bi-amping output of the BP-8, from Program mode press and hold the
<MODE/(HOLD) OUTPUT
> footswitches for 3
seconds until the display reads:
Outs
and then the currently selected output mode will be displayed. From the factory
Ster
(Stereo) will be selected. Now use the Value
<UP>
and
<DOWN>
buttons to select High - Low Bi-amping and it will appear as follows:
HiLo
Now to select the Cross-Over frequency at which the BP-8 will route the output signal to either the High or Low outputs, press the parameter
<RIGHT>
arrow button and the currently selected Cross-Over frequency will be displayed. Now use the Value
<UP>
and
<DOWN>
arrow
buttons to select the frequency. Range is from 80 to 500Hz. Once the frequency has been selected, press any foot switch to exit. This setting
will now be used with every program in the BP-8 and will be retained when the BP8 is turned off.
For more information about selecting Output, please see the Output Mode section on page 10.
Left/Low
Output
Instrument Input
Right/High
Output
BP-8 Valve
User Guide
Section -2 Setting Up
7
