Control Keypad Operation (continued)
Exit IR Learning Mode
Enter IR Learning Mode
Programming the Display On and Display Off Keypad Functions
Press and hold the HDMI button on the Control Panel for three seconds. The ON and OFF
buttons will light up.
Follow the instructions below to enter IR learning mode to program IR ON / OFF commands so
the DL-RMKTC1H1V-W keypad can control display power.
Press and hold the VGA button on the Control Panel for three seconds. The ON and OFF
buttons will go dark.
1. Press the ON button, and it will start to flash.
2. Point the display remote at the Control Panel IR sensor and the press the Power On button
on the remote. The ON button on the Control Panel will stop flashing.
3. Press the OFF button, and it will start to flash.
4. Point the display remote at the Control Panel IR sensor and the press the Power Off
button on the remote. The OFF button on the Control Panel will stop flashing.
Testing Display On / Off IR Control on Control Pad
To test the IR On and Off control functions for your display or projector simply quick press
the ON and OFF buttons on the control pad. Your display or projector should respond to the
stored IR commands appropriately, if not repeat steps 1-4 from ‘Programming the Display On
and Display Off Functions’.
IR Display Control - IR Learning Mode Configuration
