DL-HDE100 Owners Manual
6
Front and Rear Panels
Transmitter View
1
2
3
4
5
6
7
8
1. DC 18V
•
Locking power port, connect DC18V power adapter (either power port can power entire set)
2.
Twisted Pair
•
RJ45 HDBaseT connection. Connect Cat6 cable to transmitter
3. IR In
•
3.5mm IR input port for connection to IR receiver or IR system
4. IR Out
•
3.5mm IR output port for connection to IR emitter
5. RS232
•
3 pin Phoenix connector port for connecting / passing RS232 control
6.
HDMI In
•
HDMI input port for connections to video sources
7.
Ethernet
•
RJ45 port for passing Ethernet to receiver / display location
8.
Mode -
Normal-
for normal operation.
Update-
for firmware update process
•
The mode switch is used when updating firmware in the extender. A separate document will
provide usage instructions once a new firmware update is available.
Front Panel Diagnostic LEDs:
The DL-HDE100 provides four blue LEDs to indicate the current operating status and to
assist troubleshooting an installation.
Power:
Solid, the DL-HDE100 extender is receiving power from the power supply or from
the remote extender via Category 6 cabling.
Status:
Flashes once per second, the HDBaseT processor is running.
Link:
Solid, the two DL-HDE100 extenders are communicating via Category 6 cabling.
HDCP:
Solid, HDCP signal is present in the HDMI stream. Flashes quickly, no HDCP signal is
present in the HDMI stream.
Summary of Contents for DL-HDE100
Page 2: ...DL HDE100 Owners Manual 2...
