DIGITAL YACHT DTV100, Installation And Instruction Manual

Page: 4 / 4


Run a DC power cable to the amplifier box and connect to the supplied DC power cable. Power consumption is just 25mA
so connect via a small 0.5A fuse for cable protection or suitable circuit breaker. Connection colours as follows:
RED +DC 12/24V
WHITE NEGATIVE

Connect the TV via a F type patch cable (not supplied) to the TV 1 OUTPUT

Connect the FM radio via a suitable F type patch cable to the FM OUTPUT
NOTE:
Drawing shows the optional dual TV out amplifier available as an accessory. The DTV100 is supplied as standard with a single TV and single FM outlet.
Contact Digital Yacht to purchase the dual TV amplifier if required. If the dual TV out amplifier is utilised with only 1 TV, then the supplied 75 ohm
terminator should be fitted to TV OUTPUT 2 as shown above
3. Operation

Ensure all cables correctly connected as above

Check that the power supply connected to the amplifier is 12-24V DC

Switch Power button to ON,

LED indicator now should now illuminate GREEN

Set gain on amplifier to maximum and then start the channel search function on your TV. Sometimes reducing the gain of
the amplifier can improve picture quality and also the number of channels received
4. Trouble shooting
Power LED does not light:

Check power button is switched on

Check 12/24V feed to unit
No Picture Received on TV

Check cable connections from antenna to amplifier and from TV to amplifier

Try rescanning for channels especially if the boat has moved

Try rescanning for channels using a lower gain on the antenna
Shop for other marine electronics & navigation on our website.