DIGITAL YACHT LTD
Aqua Media 2 PC Quick Start Guide
Installation Step 3
On the rear of the AquaMedia PC is a single black cable that has three wires. This is the Power cable. Connect
the Red (+) and Black (-) wires in the Power
cable to the ship’s 12v or 24v supply.
Ensure that the supply is connected via a suitable fuse or suitable circuit breaker (in the positive power
connection).
A 5A fuse/circuit breaker is recommended for most installations and 10A is the maximum value that
should be used.
You will note that there is a White wire soldered to the Red wire. This is the remote switch wire and should always
be connected to the Red wire if no remote switch is required. The AquaMedia PC will not power up correctly if the
White wire is disconnected from the Red wire and no remote switch is fitted
– see wiring diagram.
Do not try to turn on the AquaMedia PC yet.
Installation Step 4
The connections on the rear of the AquaMedia PC are as follows;
Number
-
Item
1
-
PS2 Keyboard Connector
2
-
VGA monitor
3
-
USB 2.0 Ports 1+2
4
-
DVI-D Port
5
-
LAN (RJ45) Ethernet Port
6
-
Centre Sub Woofer Port (Orange)
7
-
Rear Speaker Out Port (Black)
8
-
Line In Port (Light Blue)
9
-
Line Out Port (Lime)
10 -
Microphone Port (Pink)
11 -
Side Speaker Out Port (Grey)
12 -
USB 2.0 Ports 3+4
13 -
USB 3.0 Ports 5+6
14 -
Optical S/PDIF Out Port
15 -
HDMI Port
Connect a USB mouse and keyboard to the any of the six USB ports on the AquaMedia PC
Connect a suitable monitor or monitors to the VGA, DVI-D and/or HDMI connectors on the AquaMedia PC
Feed the optional Terrestrial Digital TV antenna cable through to the AquaMedia PC and connect it to the
supplied cable (F-Type Connector)
3
14
13
12
5
6
7
11
10
9
8
15
2
4
1
