Quick Start Guide
1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To
switch between the signals:
a. Enter the camera’s OSD menu. You can access it locally from
using the camera’s joystick in the body of the camera, or from a
recorder supporting UTC communication. Go to SETUP >
OUTPUT > ANALOG MODE.
b. Set the camera’s analog signal output from the following
options:
• HD-A: supports 5MP/1944p @ 20fps and 12.5fps, 4MP/1440p
@ 30fps, 2.1MP/1080p @ 30fps and 720p @ 30fps.
• HD-T: supports 5MP/1944p @ 20fps, 4MP/1440p @ 30fps,
2.1MP/1080p @ 30fps and 720p @ 30fps.
• HD-C: supports 4MP/1440p @ 30fps, 2.1MP/1080p @ 30fps
and 720p @ 30fps.
• CVBS: supports up to 960H @ 30fps
c. Change CONFIRM to ON to save the changes.
d. Go to the EXIT menu and select SAVE&EXIT to save all changes.
The camera signal automatically.
1. Once all cables have been connected, use the screws included with
the camera to properly mount and secure the camera to the mounting
surface.
2. To adjust the camera’s tilt, loosen the screws at the base of the
camera’s bracket. The camera’s max angles are:
Pan: 0°~ 360°
Tilt: 0°~ 90°
3. To adjust the camera’s focus and zoom:
a. Remove the sunshield and front case from the camera.
b. Unlock the zoom or focus screws by rotating them
counter-clockwise.
c. Adjust the zoom and focus screws at the base of
the camera module to achieve a clear image.
d. Tighten the screws and close the front case
by rotating it clock-wise.
STEP 4 – INSTALLING THE CAMERA
STEP 3 – CHANGING THE SIGNAL IN
THE CAMERA
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Front Case
Focus Lever
Far Near
Zoom Lever
Wide Tele
Rev Date: 04/21
NOTE:
To use your Star-Light Plus™ 5MP cameras at a lower
resolution, you must use a VMAX® A1 Plus™ DVR to access
the camera’s menu due to the cameras being set to 5MP as
the default. A DVR that does not support 5MP resolution
may recognize the camera, but will not deliver a picture