Installation
Installation -
Adjusting the camera’s angle and view and tighten the
pan/tilt/rotate screws to lock the camera’s position.
1
2
3
Using the mounting template sheet or the camera itself,
mark and drill the necessary holes in the wall or ceiling.
Connect the network cable and power cable
respectively. See 'Installation - Cabling' for details.
Use the two mounting screws to mount the camera
on the mounting surface.
4
Remove the protective film from the camera’s
lens to complete the installation.
5
a
b
c
To use the camera’s waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
Loosen the pan/tilt/rotate screws a little before fixing
the camera.
2
4
5
3
3
2
1
Mounting Template
NOTE: To ensure moisture seal, make sure the o-ring is in
place between (a) and (b). In extreme environments use
of an outdoor rated sealer is recommended.
NOTE: When using the waterproof cap, crimp the RJ45
connector after passing the cable through the
waterproof cap.
8