Feed the hose bands through the vertical stills located on the four corners
of the mounting flaps as shown to the right. Wrap the hose bands around
the pole like structure then use the driver to rotate the screw attached
at the end of the hose bands clockwise. Rotating the screw shortens the
bands, thereby fastening around the structure.
Using the appropriate screws and nuts supplied, affix the power
box base to the pole and corner mount at the four corners of the
mounting surface.
Using the appropriate screws and nuts supplied, affix the wall mount to the pole and corner mount at the four corners of the
mounting surface as shown below.
A - Installation using DWC-P336WM
B - Installation using DWC-P220WM
Using the pole and mounting bracket as a template, mark the
locations of the six screw holes where the mounting adaptor will
go. Install the plastic anchors (D6) at the six pre-marked locations.
Use the screws with washers to affix the mount adaptor to the
corner of a building structure.
COMPOSITION
Quick Start Guide
Tapping screw
BH 6x50L stainless
steel
Plastic anchor (D6)
Mounting the accessory to a structure’s pole
Mounting the accessory to a structure’s corner
Mounting a power box to the pole and corner mount bracket
Stainless hose band
D= 10.24” (260mm)
Screw Machine (SEMS)
PH M8x35L
Screw Machine (SEMS)
PH M6x25L
B
A
Nut M8
Machine screw (SEMS)
PH M8x35L
A
Machine screw (SEMS)
PH M6x25L
B
Rev Date: 01/20
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
