A.
Attach the mount base ( ) and plate ( ) to the ceiling or wall using the supplied M6 tapping
screws ( ) and plastic bushings ( ).
B.
Wind Teflon tape around both threaded ends of the pipe (about 20 times) for sealing. If necessary,
use a silicone rubber sealant to seal the area where the mount base and the pipe meet.
C.
Fit the pipe (of which threads are covered by Teflon tape) into the mount base ( ) and turn until it
is securely fastened.
D.
Pull all the required cables through the mount base ( ) and pipe ( ).
E.
Align the dome adaptor ( ) with the pipe and turn until it is securely fastened.
F.
Fasten the mount base ( ), dome adaptor ( ) using the set screw.
G.
Fasten the vandal proof dome housing to the dome adaptor ( ) using M6 x 12 machine screw.
INSTALLING THE MOUNTING ACCESSORY
Rev Date: 02/17
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Quick Start Guide
5
6
6
6
6
1
1
1
1
4
3
2
Without Junction Box
1
4
3
2
Cable
With Junction Box
1
2
Cable
Junction Box
Seal around the mount base
tightly using silicon rubber
5
1
How to install the plate
Specifications
Dimensions (mm)
1. Cable passing through the wall
2. Cable on the wall (Remove the conduit
knockout for cable passing through)
3. Cable passing through the
wall with the junction box
(Attention to the plate side)
Cable
Mount
Base
Plate
Cable
Junction
Box
Mount
Base
Plate
Cable
Mount
Base
Plate
Knockout
Mount Base
