7
Installation -
Installation
Mounting Template
Reset Button
Before installing your camera, you have to read the following cautions.
1. The mounting surface must withstand five times the camera weight.
2. Do not let the cables get caught in improper places or the electric line cover can be damaged. This may
cause a short or fire.
1. Using the mounting template sheet or the
camera itself, mark and drill the necessary
holes in the wall or ceiling.
2. Pass the wires through the mount bracket and
make all necessary connections. See page 12
for more information.
3. To use the camera’s waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
NOTE: to ensure a proper moisture seal,
make sure the o-ring is in place between (a)
and (b). In extreme environments, use an
outdoor-rated sealer.
NOTE: When using the waterproof cap,
crimp the RJ-45 connected after passing the
camera through the waterproof cap.
4. Fix the camera's bracket to the mounting
surface using the screws provided.
5. If needed, adjust the
camera's tilt by
loosening the pan/tilt
stopper screw.
6. Once the camera's
tilt and panning are
adjusted, secure the
stopper screw back.
a
b
c
Reset to the Factory Default
Press the reset button for 5 seconds to return the
setup to the factory default.
Warning:
If you press the ‘Reset’ button, you will lose all
setting data. If needed, please, make a note for
further installation.
