Rev Date: 04/21
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Quick Start Guide
1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To switch between the signals:
a. Remove the camera’s dome to access the joystick and OSD control on the base of the camera.
b. Use the OSD Switch to switch the camera’s signal.
• To switch the camera to HD-TVI mode, press OSD joystick to the left for 5 seconds.
• To switch the camera to HD-Analog mode, press OSD joystick to the right for 5 seconds.
• To switch the camera to CVBS mode, press OSD joystick up for 5 seconds.
• To switch the camera to HD- CVI mode, press OSD joystick down for 5 seconds.
STEP 5 – INSTALLING THE CAMERA
STEP 4 – CHANGING THE SIGNAL IN THE CAMERA
Zoom lever
Wide Tele
Focus lever
Far Near
Test video connector for
on-site configuration
1. Once all cables have been connected, use the screws included with the camera to properly mount
and secure the camera to the mounting surface.
2. To adjust the camera’s tilt, loosen the screws at the base of the camera’s bracket.
The camera’s max angles are:
Pan: 0°~ 360°
Tilt: 0°~ 90°
3. To adjust the camera’s focus and zoom:
a. Remove the sun-shield and front case from the camera.
b. Unlock the zoom or focus screws by rotating them counterclockwise.
c. Use the wrench included to adjust the zoom and focus screws at the base
of the camera module to achieve a clear image.
d. Tighten the screws and close the front case
by rotating it clockwise.
HD-A
HD-TVI
CVBS(960H)
HD-CVI
U
Enter
R
L
D
Right
Up
2ND
EX-CO
N
Down
