2/5/2007
To contact Technical Support please call 770-420-1350
4
Set the SHOW position.
1. Send the TheaterScope to its Home position by using button 3. The Home position will be
indicated by the green LED. If the LED turns red, the TheaterScope is at the wrong end. Move
the TheaterScope to its Home position.
2. Move the TheaterScope to the Show position by using button 2. If you go past the desired
show position use button 3 to go back.
3. To program the SHOW position, press and hold
button 1
then press
button 2
. Release
button 2
, and then release
button 1
.
4. To return to automatic mode, cycle power to the TheaterScope.
Note: The 3 buttons are only used to program the TheaterScope. They have no functionality
in automatic mode.
In Automatic mode:
5. Use your desired means of control to send the TheaterScope to its home position.
6. Test the operation of the TheaterScope to verify it has accepted your program.
7. Press the
SHOW
button. The TheaterScope should move to the desired show position. If the
TheaterScope does not travel to the desired position, repeat this programming process.
If using the switch method of control. On power-up, the TheaterScope may first go to the show
limit, but it will then move to the home position. After traveling to the home position, the
TheaterScope will travel to the desired show position. If it does not travel to the desired show
position, repeat this process.
Infrared Control
The
Position 1
button sends the TheaterScope to its
HOME
position
The
Position 2
button sends the TheaterScope to the desired
SHOW
position
POS 1
POS 2
