2/5/2007
To contact Technical Support please call 770-420-1350
3
Operating the TheaterScope
Safety Note
Be sure to keep hands & fingers and any loose clothing away from any moving parts
Automatic mode
The TheaterScope powers-up in automatic mode. On power-up the LED flashes green multiple
times, and then turns a solid color when the unit is ready for operation.
Depending on the position of the TheaterScope, the led will be different colors.
Solid Green = Home position.
Solid Red = other limit of travel.
Solid Amber = in between limits.
The Led will blink with the Amber color while the TheaterScope is moving.
Control
You may use any of the following means to control the TheaterScope:
•
Infrared Control
•
RS-232 Serial / Computer Control
•
Single Latching Relay
Programming the TheaterScope
To enter Programming mode:
1. Hold down
buttons 1, 2, and 3
while powering up the TheaterScope. The LED will flash
green, and then turn red to indicate that you have entered programming mode. Release all
buttons when the LED turns a solid red.
2. Test the unit by pressing buttons 2 or 3. It should move only when the button is depressed.
The TheaterScope will stop when the button is released. In manual mode the led colors are
the same as they are in automatic mode.
3. The TheaterScope has a default setting of operating on a LENS-CENTERED projector (i.e.
Mercury, Titan).
Only if your projector is LENS-LEFT (i.e. dVision), make the
following programming change:
•
While in programming mode, hold button 1 for 10 seconds until the led flashes, then
release button 1. This will reverse the direction of the TheaterScope to function
properly with your LENS-LEFT projector.
1
2
3
Programming
Buttons
All manuals and user guides at all-guides.com