Digital Projection
LIGHTNING
i
sx+, 1080p, Reference 1080p
Page 6
Rev B. April 2008
Installation precautions
Connect the LAN cable only to a computer LAN connection. Other similar connectors
may have a dangerously high voltage source.
The projector must be installed only by suitably quali
fi
ed personnel, in accordance with
local building codes.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be disconnected in an
emergency.
Ensure that there is at least 30cm (12in) of space between the ventilation outlets and
any wall, and 10cm (4in) on all other sides.
Do not install the projector close to anything that might be affected by its operational
heat, for instance, polystyrene ceiling tiles, curtains etc.
The projector weighs over 100kg (200lbs). Use safe handling techniques when lifting
the projector.
Do not stack more than four projectors.
When stacking projectors, the stack MUST be vertical, to ensure that the stresses are
distributed to all for frame couplings.
Before installation, make sure that the surface, ceiling or rigging that is to support the
projector is capable of supporting the combined weight of the projector and lens
(see
speci
fi
cation for exact weights)
.
Separate backup safety chains or wires should always be used for each projector.
Do not place heavy objects on top of the projector chassis. Only the rigging frame is
capable of withstanding the weight of another projector.
Do not drop or jarr the projector.
The lens release lever should always be set to the locked position to prevent the lens
from falling out.
Place the projector in a dry area away from sources of dust, moisture, steam, smoke,
sunlight or heat.
Do not tilt the projector more than ±12° from side to side when in use, as this may
cause serious lamp failure, damage the lamp module and cause extra cost on
replacement. The projector my be tilted
forwards and backwards as necessary.
±12°
360°
English
