Using the projector
Digital Projection E-Vision Laser 15000 Series
Edge Blend
Edge Blend
Edge Blend
On
Align Pattern
Off
Blend Start
►
Blend Width
►
Black Level Uplift
►
Reset
When
Edge Blend
is set to
Off
, all
other edge blend settings are
disabled.
The picture in the blend region
needs to be delivered to all
overlapping projectors, which may
require a special setup of the
source.
Use this menu to blend together images from an array of two or more projectors. The feature feathers the light
output of the projector within the edges that overlap with other projectors in the array: as a result, the
overlapping edges are evenly lit and easily blend in with the rest of the image.
l
Edge Blend
Enable and disable
Edge Blend
l
Align Pattern
Add markers to the image showing the edges of the blend area and making the overlaps more visible
to help adjust the physical position of the projectors in the array.
l
Blend Start
Determine the start point of the blended regions. top, bottom, left right
l
Blend Width
Determine the width of the blended regions.
l
Black Level Uplift
Adjust black levels to compensate if the blended regions appear brighter than the rest of the image.
l
Reset
Reset all
Edge Blend
settings to their factory default values.
Operating Guide
Rev B April 2021
page 79
Notes